Centrifugal Sludge Dewatering Decanter Biological Treatment Of Wastewater Grey

Dewatering machine is the body of fixing ring and moving ring stacked with each other, screw

shaft runs through the filter, the front for the department of concentration, later for the

department of dehydration.

Fixed filter joint formed between the fixing ring and moving ring and the pitch of sspiral shaft

from enrichment to dehydration becomes small.

Rotation of the screw shaft in the promotion form the department enrichment to dehydration

dewatering of sludge at the same time, have been driven floating ring cleaning filter joint to

prevent jams.

Sludge enrichment section after gravity concentration, is transported to the dehydration unit, in

the process of moving forward with the next pitch joints and filter blocking effect becomes

smaller, and the back pressure plate, resulting in great internal pressure, the volume is

shrinking to charge.

Advantage

Iso9001 Certificated Sludge Dewatering Machine

1. Widely Use

Municipal wastewater, papermaking wastewater, chemical waste water, food and beverage processing

waste water, industrial wastewater, papermaking wastewater, pharmaceutical wastewater, oil processing

and mining wastewater, etc.

2. Fully Automatic Control

Combining with the auto control system, the machine runs very safely and simply and can be programmed

according to the requirement of the users. It can operate automatically for 24 hours, unmanned.

3. Low Running Cost

Main body can self-cleaning due to the special structure, threr is no need to use a lot of water for cleaning

to prevent clogging. Compared with the same capacity of dewatering machine, screw rinse water

consumption is only 1% of belt . The rotation speed of screw shaft is 2-5 turn/min , low power

consumption. Power consumption is only 5% of the centrifuge, at the same time, no noise during

operation as slow rotation speed and intermittent flush.

4. Non-clogging

The dewatering body is formed by a screw axis with fixing and moving plates overlapping, as the inner

diameter of screw axis is larger than the moving plate, the moving plate do the circular motion with the

screw axis to prevent clogging, to ensure the continuous operation.

Technical parameters